Addonics Technologies Computer Drive HDMU3 User Manual

T E C H N O L O G I E S  
User Guide  
Mini HDD Duplicator Station  
(HDMU3)  
Technical Support  
If you need any assistance to get your unit functioning properly, please have your  
product information ready and contact Addonics Technical Support at:  
Hours: 8:30 am - 6:00 pm PST  
Phone: 408-453-6212  
 
Eject buttons: Press down firmly to unseat the drive from the SATA connector  
inside the unit.  
Power LED: Glows to indicate the unit is powered up.  
Disk LED (Disk1 and Disk2): Glows to indicate a drive is connected and powered  
up, blinks to indicate activity.  
Duplication Progress LEDs: When connected to a USB host, these blink in  
unison to indicate I/O activity. With no host connected, they will remain dark until a  
copy operation is started.  
Clone Button: Press and hold for three seconds to start copying from Disk1 to  
Disk2, when no USB host is connected.  
Backup Button: Press to launch the HDMU3 backup utility.  
Disk Cloning  
1. Be sure to insert the SOURCE drive into the Disk1 slot and the TARGET drive  
into the Disk2 slot.  
2. The TARGET drive must be equal to or greater than the capacity of the  
SOURCE drive.  
3. Power up the unit with the SOURCE and TARGET drives inserted and the USB  
cable disconnected, then wait a few moments for the drives to become ready.  
4. Press and hold the Clone button for three seconds.  
The unit will then blink the Disk1 and Disk2 LEDs to indicate activity, then if no  
errors occur, the Progress LEDs will begin flashing in a back-and-forth pattern, and  
as the process completes past each percentage on an LED, that LED will glow  
steadily and the remaining LEDs will continue the pattern. When all four LEDs are  
glowing steadily, the process is complete.  
If there is an error after starting the copy process, all four Progress LEDs will blink  
rapidly in unison, and the LED associated with the drive having a problem will  
remain dark. For example, if the TARGET drive is not equal to or greater than the  
capacity of the SOURCE, holding the Clone button will cause all four Progress  
LEDs to blink rapidly, the Disk1 LED will be glowing, and the Disk2 LED will be  
dark.  
Using the One-Touch Backup Feature  
The backup utility is provided on CD or download with its own user guide. Once  
installed and the backup settings are in place, pressing the Backup button will  
launch the backup utility from the system tray and begin the backup process  
automatically.  
 
Technical Support (M-F 8:30am - 6:00pm PST)  
Phone: 408-453-6212  
CONTACT US  
Phone:  
Fax:  
408-573-8580  
408-573-8588  
Email:  
 

Acnodes Car Video System RM 6193 User Manual
Aiphone Intercom System RY ES User Manual
Alto Shaam Food Warmer PD2SYS 48 User Manual
Aluratek Digital Photo Frame ADEQ108F User Manual
American Audio Mouse WM 16HH User Manual
American Dryer Corp Clothes Dryer AD 120ES III User Manual
Aspire Digital Laptop 1360 User Manual
Audiovox Camcorder EZ207MD User Manual
Audiovox Stereo Amplifier PAB 1500D User Manual
Audiovox Stereo Amplifier PA S250 User Manual