Addonics Technologies AESN5DA35 User Manual

T E C H N O L O G I E S  
User Guide  
Snap-In Disk Array  
(AESN5DA35)  
v6.1.11  
Technical Support  
If you need any assistance to get your unit functioning properly, please have your  
product information ready and contact Addonics Technical Support at:  
Hours: 8:30 am - 6:00 pm PST  
Phone: 408-453-6212  
Installing the Snap-In Disk Array  
Standard 5.25” Drive Bay  
1. Slide the Snap-In Disk Array into a set of  
three standard 5.25” drive bays on your  
system or storage chassis. Orient the Disk  
Array so that the drive door open to the right  
in horizontal mount or swing open downward  
in vertical mount. Be sure there is no  
metal tabs on the inside of any one of the  
three drive bays that may interfere with the  
installation.  
2. Secure the Snap-In Disk Array to the drive  
bay on both sides with the screws that come  
with the unit. Note: using other long screws  
may interfere with the hard drive  
installation.  
3. Connect the two 4-pin Molex power  
connectors on the Disk Array unit to the  
system power supply  
Use a plier to shift  
the metal tabs to  
face vertically or  
remove the metal  
tabs  
4. Connect the 4 SATA connectors to SATA  
host or the 4 SAS connector to SAS host in  
your system  
5. Power on your system. Check to make  
sure the main power LED is lit and that the  
two cooling fans are spinning.  
Adding and removing hard drives  
from the Snap-In Disk Array  
1.  
Be sure the lock on each drive door is in an unlock position. If not, use the key that  
comes with the Disk Array to unlock the drive door. Pull on the door lever to swing open  
the drive door all the way.  
2.  
Slide a 3.5” SATA hard drive into the drive slot with the drive connector side facing in.  
Be sure to orient the hard drive correctly as shown in the yellow label on the inside of  
the drive door – with drive door swing open at the bottom, the top of the hard drive  
should face to the right. The drive should slide all the way into the slot with very  
little resistance. Forcing the drive into the slot will cause drive damage or  
permanent damage to the Disk Array.  
3.  
4.  
Once the drive is all the way into the drive slot, close the door all the way till the drive  
door latch securely. This will engage power and data connection with the hard drive.  
The LED lit for the drive slot should lit if the Disk Array already powered on. You may  
lock the drive door with the key  
To remove the hard drive from the Disk Array, simply follow the step 2 – 3 in reverse.  
Technical Support (M-F 8:30am - 6:00pm PST)  
Phone: 408-453-6212  
CONTACT US  
Phone:  
Fax:  
408-573-8580  
408-573-8588  
Email:  

Motorola MB300 User Manual
Morphy Richards 28027 User Manual
Hamilton Beach 47304 User Manual
Fujitsu MHW2040AC User Manual
Ecom Instruments Ex Handy 05 User Manual
Creek Audio Destiny 2 User Manual
Bryston BCD 1 User Manual
Bell 330D User Manual
Apple MULTIPLE SCAN 15AV User Manual
ABB TPS48 H32 User Manual